How to check Raw Data
By pressing ALT-F2 at the initial main menu will display a black screen which will show the raw data coming from the base unit.The screen MUST be in 16 color mode for this to work properly.
To set color mode - right click in an empty space on the windows desktop and select 'Properties' from the popup menu - then select the Settings Tab
This is only necessary for this particular test and should be returned to your full color mode after test is complete.
The following screenshots show some typical responses when the laser club is swung over the base unit
This shows the results of sweeping the red D image of the clubhead over sensors as in a normal swing.
The unit is put into swing mode by first projecting the D image over any sensor in the first row from 0 to 3 and then moving the D image back off the sensors.
The green led should then stay on for at least 8 seconds waiting for you to take a swing.
This shows the results of sweeping the red D image of the clubhead over sensors 0 to 3
This shows the results of sweeping the red D image of the clubhead over sensors 7 to 4
This shows some typical results of sweeping the red D image of the clubhead over the sensors as in a normal swing, but when the batteries are getting low in power.